Roof lighting struc...
 
Notifications
Clear all

Roof lighting structure?

12 Posts
7 Users
0 Reactions
3,850 Views
Steven010
Posts: 416
Topic starter
(@steven010)
Honorable Member
Joined: 18 years ago
[#42374]

We are thinking about retiring our GECEs this year on roof and placing pixels. Along with that, we would like to investigate new methods of placing pixels on roof. GIVEN- today we have GECE bulbs zip tied to 36 1/2 EMT conduits, 20ft long, laying on side equally spaced across roof. Roof pitch is low, like 4.5. single story ranch house. Not exactly ideal viewing angle for audience, but works OK and was cheap.

My initial thought was Boscoyo strips, which I bought, and anchored and stretched between two 2x3 frames, one at top of roof and one at bottom of roof. However, the more I experiment with this, the more I don't think will be good option. The strips will not sit flat on roof as the wires on the pixel get in way, and they droop. my next thought is to use 1/2 EMT and strap/ziptie Boscoyo to EMT on one edge. Again, still worried this will not work.

DESIGN GOALS;

1. Inexpensive mechanics;
2. Easy to put up, take down
3. (stretch goal) - good viewing angle for audience

I would love to hear what others have done;


11 Replies
Posts: 944
(@didjareally)
Noble Member
Joined: 12 years ago
Reply
Posts: 451
(@utimgr)
Honorable Member
Joined: 14 years ago

I was looking at wire race ways. Downside is, a bunch of work drilling holes in them. Of course I'm looking at installing them on a permanent basis, so a bit of work would be worth it in the long term, and painting them to match the trim color


Reply
Steven010
Posts: 416
Topic starter
(@steven010)
Honorable Member
Joined: 18 years ago

Correct me if I am wrong; This is for the ridge only, not the bulk of roof itself. This is more for outline of roof.


Reply
Posts: 944
(@didjareally)
Noble Member
Joined: 12 years ago
Steven010 wrote:Correct me if I am wrong; This is for the ridge only, not the bulk of roof itself. This is more for outline of roof.

yes it is, sorry i misread your original post. What kind of spacing are you wanting and are you using bullet or square nodes?


Reply
Page 1 / 3
Share: