First year question...
 
Notifications
Clear all

First year questions about setup.

11 Posts
6 Users
0 Reactions
1,849 Views
Posts: 33
Topic starter
(@jbair)
Trusted Member
Joined: 5 years ago
[#57467]

This was my first year of doing a light show. I have around 1800 pixels and more to come next year. I am using ESPixelPops. I have six of them on the network. The show plays but is jerky. As usual I always try to be as cheap as possible which usually comes back to bite me.

The setup I have is ESPixelPop controllers, a wireless AP, and a windows computer which is connected to the AP with an Ethernet cable. I am using Xlight scheduler to play the sequences. The lowest WiFi signal is around 60%. But even the ones with 95% hesitate too.

I would appreciate any advice you can give me. What would be the ultimate computer, operating system, router or AP, and player using the ESPixelPops. Is there special settings that I need to use in the AP? As I said before I will be adding more pixels next year (upping to around 16000 pixels) and I want things to work.

Thanks again for any suggestions.

Sent from my iPhone using Tapatalk


10 Replies
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

Assume you are use espixelstick firmware? What version?

How many pixels per pop? Evenly distributed or some heavier than others?

Did you pack the universes?

Are you using unicast or multicast?

What is the data rate to the controllers?

What does your wifi spectrum look like in the show vicinity?

Espixelstick firmware with newer hardware can support an SDCard. With sequences on the sdcard, you can avoid sending data across the wifi and just send small packets that tell the espixelstick what to play and where in the sequence it should be playing. If you like the wireless and are going with that many pixels, you definitely need that type of hardware. The espixelpops don't currently have support for the ESPs that can use SDCards.

In the Christmas light community, there used to be a Ubiquity AP that was well used and some folks spent time finding and setting parameters on it. However, that AP has been discontinued and so you are kind of on your own for a "good one". You want one that will process multicast at a high rate. The ESPs we currently have are not very sophisticated so no need for a powerful wifi 6 spectrum hopping channel merging mega AP. (Of course that could change if someone comes out with a low cost controller that had those features).

For a player, you might try FPP running on a raspberry pi. There seemed be higher complaints than normal this year with V7 but generally stable, inexpensive, low power requirements, works well, does a few things for running the show that other hardware (PCs) has a hard time with.


Reply
Posts: 33
Topic starter
(@jbair)
Trusted Member
Joined: 5 years ago

I will get you the information tomorrow. Thanks

Sent from my iPhone using Tapatalk


Reply
Posts: 116
(@coaster)
Estimable Member
Joined: 15 years ago

The Ubiquity NanoStation loco M2 is available on Ebay. Both new old stock and pre-owned


Reply
Posts: 418
(@richienorthcott)
Reputable Member
Joined: 7 years ago

I don't have have much experience with this - but had a bad time with it and went wired very early on. It didn't add much to the budget (though depends on your physical space). For Wi-Fi Multicast is your friend - also what's going on the neighbourhood can have a big effect things e.g. number of other nearby networks. I can't recommend any particular APs.


Reply
Page 1 / 3
Share: