Hey there, long time lurker, first time poster.
This is my 2nd year doing my home light show and I am having the absolute worst luck with my Pixels. I kind of assumed that I would get at least 3 seasons out of them before having to replace strings (12mm bullets and squares).
One pixel will fail and screw up the whole string. I've been successful in just replacing the 1 bad LED but it's getting out of control this year. I've had at least 6-8 strings give out or just stay on randomly or just change colors. I'll replace the bad pixel, then it just fails a few pixels down the line.
Is this the norm? I live in Florida and we've been getting pelted with bad weather this year, lots of wind and rain, but again, kind of assumed these things were meant to be out in the elements.
To make matters more laughable, my first set of pixels I bought from Amazon because I didn't know any better, haven't had a single failure out of those and they're actually on year 3, yet pixels bought from what I thought were reputable vendors are dropping like flies on year 2.
Really just wanted to see what you guys opinions on lifespan are because this has me second guessing continuing to do my show after having to spend days re-doing my roofline due to these failures. I know failures are to be expected, but I consider this pretty excessive.
I am losing an average of 4 pixels a week out of 14000 in the show. This has been pretty consistent for the past few years. I do not count the order of crap I got from Ray Wu which have been completely flushed out of the show. I was replacing 10/day of those.
MartinMueller2003 wrote:I am losing an average of 4 pixels a week out of 14000 in the show. This has been pretty consistent for the past few years. I do not count the order of crap I got from Ray Wu which have been completely flushed out of the show. I was replacing 10/day of those.
Man that's discouraging. I have about 6000 in my show this year and another 5000 in the garage for next year.
I have been doing a lot of reading about quicker/more effcient methods of repairing strings in place. I ordered some of those "Click-It" things, hoping that reduces the burden.
Also, how are you guys verifying which pixel needs to be replaced? Sometimes it seems pretty obvious which one is bad, I'll cut out the last working one and the first not working one and 9 times out of 10 that takes care of it, but I have a few strings that just have failures all over them, guess I should probably just replace the whole string, but it's on my roofline which is much more difficult to replace an entire string. (Picture below)
Roof1 - 2 random blue pixels + half the back end just stays lit up even when shouldn't be lit.
Roof2 - Same as Roof 1, random set of pixels just stay on, but when the show is running, they work as intended.
Star - Same as Roof2, random pixels just stay on, but prop still animates normal when show is running.
Do you have the controller sending "off" while a sequence is not being played? A pixel will show the last data it was sent. If there is any noise on your data line, you can see artifacts like these.
MartinMueller2003 wrote:Do you have the controller sending "off" while a sequence is not being played? A pixel will show the last data it was sent. If there is any noise on your data line, you can see artifacts like these.
I will have to verify. I would assume it's on by default because I don't recall selecting that option, of the 2 previous years I've had my show I've never had any lights stay on like this.



