I'm going over my display setup for 2020 (first display) and I'm trying to understand the specification sheet on the Falcon F48. If I'm trying to run my show at 40fps the spec sheet says,
Refresh Rate (up to 680 pixels per output group)
I'm having trouble understanding an "output group." On the smart receivers there are 4 ouput ports. Is the spec sheet meaning a max of 680 pixels on each of the 4 ports or the sum of all 4 ports has a max of 680? Or am I completely off and it means something else?
680 pixels per receiver output port, so it’s a total of 2,720 pixels per receiver.
fantastic! Thank you!
Litebrite wrote:I'm going over my display setup for 2020 (first display) and I'm trying to understand the specification sheet on the Falcon F48. If I'm trying to run my show at 40fps the spec sheet says, I'm having trouble understanding an "output group." On the smart receivers there are 4 ouput ports. Is the spec sheet meaning a max of 680 pixels on each of the 4 ports or the sum of all 4 ports has a max of 680? Or am I completely off and it means something else?
There’s a slider in the web interface to adjust the number of pixels per group. You can set one group for more pixels per port or less depending on your needs.
Sent from my iPhone using Tapatalk
And you have to consider the "Smart Receivers" where you can Daisy Chain them, the 680 is spread across all the receivers in the chain, ie you cannot have 680 on each
Sent from my ASUS_A009 using Tapatalk
