Are Square node pix...
 
Notifications
Clear all

Are Square node pixels not good to use???

13 Posts
9 Users
0 Reactions
6,208 Views
Posts: 43
Topic starter
(@litebrite)
Trusted Member
Joined: 7 years ago
[#52197]

I was looking around on the Wiki and found an article about different kind of pixels and came across this;

12mm pixel node (square / flat) - These pixels can come with the wire coming either out of the back of the Pixel or the side of the Pixel. There has been some issues with the silicone injection molded units that have the wires coming out of the side not sealing and allowing water into the pixels.

Is this true? I see on the DIYLEDexpress page that their square pixels have the wiring coming out of the back of their square nodes not the sides.


12 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Make sure you order epoxy filled and you are golden !


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

Many of the styles of pixels had water intrusion issues in their infancy. With the advances made in construction and assembly, most all of them that are rated IP67 or 68 are waterproof any more.


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

This was an older issue. There used to be a square node type that had the wires coming out of the side and had the plastic shell injection molded around the wires. Those did have water intrusion issues. Though I haven't seen those in a long time now. most modern pixels are encapsulated in epoxy. That includes both square nodes and bullets. This seems to have cured all of the water issues. As a result of the epoxy process, you can't really have the wires coming out the sides. There needs to be a cup to be filled that holds the epoxy during assembly. so modern square nodes still tend to have the wires coming out the back. They're still a bit flatter than bullets though.

The IP rating really has nothing to do with it. Those are just numbers that manufacturers slap onto the products, they're not tested to those specs. Look at how they're made, not the claims on the spec sheets. The difference between IP67 and 68 is whether you can submerse them less than 1m in water, or more than 1m in water. Both are overkill for most of what we're doing. Even an IP 64 or 65 should be good for use in outdoor lighting applications. The bottom line is that the ratings can't be trusted unless they're independently tested, which you're not going to get at the pixel prices we're willing to pay.


Reply
Kev7274
Posts: 2037
(@kev7274)
Famed Member
Joined: 13 years ago

I've used square pixels with my bullet pixels for the last few years with no issues.


Reply
Page 1 / 3
Share: