You could see if the second pixel gets hot to the touch. I had a stand of about 118 and found an issue at pixel 71. The lights stopped after it and everything was set up correctly. Then I held the first pixel that was out and it was pretty darm warm. I let it cool down and tried again and the same thing, it was the only pixel that was warm. SO I cut it out and soldered in a new pixel at 71 and everything worked fine.
Turns out it was the pixel. When I first saw that it was a purplish color when it should have been white, I thought power or data connection. But it was simply the pixel. As it turns out, only one of the 24 strings of pixels that I purchased did not entirely work. I thought I had cut out all of the bad pixels but this one got me.
Thanks for all of the help and suggestions.
I have a strand with 13’ between pixels and works just fine. I use 2 https://www.amazon.com/dp/B01MZYUVLW?ref=yo_pop_ma_sw f">18 gauge Plus 14 gauge ground.

