Extending Distance ...
 
Notifications
Clear all

Extending Distance Between Pixels

14 Posts
9 Users
0 Reactions
4,567 Views
Posts: 1387
 kev
Topic starter
(@kev)
Noble Member
Joined: 12 years ago
[#47072]

So I want to have some "Stars" above my house, points of light suspended between two poles. I thought that I could just add 2' - 5' of cable between pixels and all would be joyous. But when I add 3 conductor 18 awg cable between pixels, I get the dreaded purple white color. I'm thinking that it is a DATA wire issue. I was thinking that if I used Cat5 the twists would help. I can buy shielded or un-shielded cable.

What do you think?


13 Replies
Posts: 151
(@bf210)
Estimable Member
Joined: 18 years ago

RobG makes a signal amplifier that goes in between your pixel Here is a thread about it and some similar solutions.
http://doityourselfchristmas.com/forums/showthread.php?47393-Buffer-line-driver-null-pixel-without-pixel


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

2' to 5' should not be a problem for the data re-transmission for the prior pixel. This then leads to the question of how is your power levels at each of these pixels?

Low power at a pixel can yield you many different things, most of which I would not want to have happening out in my show. As you have seen, low power can cause your lights to go "pink", but it also can cause the transmission side of your pixel's chip to misbehave as well.


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

You might try Cat5 or Cat6, stranded and Unshielded. Use all of the solid colors for ground, orange/white for data, and the rest of the colors with white as V+.


Reply
Posts: 1387
 kev
Topic starter
(@kev)
Noble Member
Joined: 12 years ago
algerdes wrote:2' to 5' should not be a problem for the data re-transmission for the prior pixel. This then leads to the question of how is your power levels at each of these pixels?

Low power at a pixel can yield you many different things, most of which I would not want to have happening out in my show. As you have seen, low power can cause your lights to go "pink", but it also can cause the transmission side of your pixel's chip to misbehave as well.

I thought 2 - 5 feet would be OK also. More info - I test after each pixel extension. On the second pixel I get the dreaded pink/purple color. I removed the soldered extension and soldered another. Same result.
I am going to get a spool of CAT5 and will try using it.


Reply
Page 1 / 3
Share: