I used by K32 in power off/power on mode all Christmas 2021. We've got yard inflatables which draw several amps of 120vac current, unrelated to the controllers. I don't recall experiencing any issues related to that. As a precaution, though, I did pull off about 40% of my display to run off of my backyard breaker instead of my frontyard, and I further subdivided my frontyard to run on two different timers, which turned on about 5 minutes apart.
A lot of it had to do with the daylight: the yard inflatables are still pretty when there's daylight. The lights need it to be more dusky before they stick out.
Thanks. I'll keep that in mind.
I am not familiar with your hardware and I am only half alert right now so I apologize if this is completely off base....
If I understand it, the root of the problem is that you lose "line power" to a portion of your display every day. Would it help to have something like this:
Co-locate a large power bank (or car battery (with whatever is needed to get the output correct) with an AC charger) in the area of interest and plug in into the area line power so that the power bank recharges whenever the line power is on. Then use the power bank to supply power only to the scheduler or controller and not to the prop. The scheduler/controller is ALWAYS running off the power bank and the power bank is being recharged whenever it can be.
--je
I should probably add that I used my K32 in 5V mode--not 12. It sounds like the concern is that ground bounce from a power cycle slowly erodes at the K8, and that would involve the regulator. K8's don't cost that much, so I don't think the risk level is high. I do a staggered power cycle on my display, mostly to not risk tripping the GFCI. Any such bounces would probably trip the GFCI first. But also, I just like to turn on my stuff that looks good in the daytime first, and turn off my noisy stuff late at night first.
Just so we understand the scope of this...
Horner Park is a 55 acre park with a mile long drive entering on the northeast corner and proceeding around the lake, down behind the dam, up again across the dam, and then to the gate on the southeast corner. We have a parking lot adjacent to "Mole Valley", where the animated light show is. The primary location of all "blinky" is in Mole Valley. These props, simply 4' tall, 5 foot wide matrices are located in a larger field just inside the north gate.
The attached screenshot of the Google Map of the park shows the 3 "AC Power" areas. These areas are each controlled by a power box that is shut down each night. No other power is available. In fact, the only power that remains on 24/7 is for the animated show area, designated by the gold area next to Horner Park Hall.


