I'm likely behind the times, but...
What exactly does V3 or V4 version number refer to? The main board (pixel driver) hardware or the firmware version that could be loaded into the top module, or some mixture of the two? And how does the matter of ESP32 vs ESP8266 figure into this?
V3 refers to a product that Shelby sells on Amazon etc. It is an ESP8266 + base card implementation and comes with V3 software.
V4 is a restructuring of the ESPixelStick Software that is backwards compatible with the V3 hardware (ESP8266 + Base card) and uses more of the capabilities of the V3 base card.
V4 adds more pixel protocols on the V3 hardware.
V4 supports the ESP32 based D1 Mini cards that plug into the V3 base card. This increases the number of pixels that the V3 hardware can drive.
V4 adds support for OTHER DIY hardware base cards (look at Quinled as an example) that increases the number of ports (max eleven) with support for SPI based pixels (WS2801 etc.)
V4 adds support for Ethernet for base cards that have that built in.
Hope this helps.
Martin
Point 4 extended explanation: V4 on Esp32 (D1 format boards) will also run multi pins. which is what I have done on a couple of mine.
Also V4 has SD card support.
Is there a page (or pages) that explains all of this, both the ESPixelStick based controllers/software, the various other controllers, and various sequencing software anywhere? I haven't seen anything (which is why I asked the question originally), but then I might be missint it because I haven't spent any time of the DIYChristmas.org site nor the Aus sites.
There is an explanation of the FPP Remote mode functionality at https://github.com/forkineye/ESPixelStick/wiki/Supported-Inputs-and-Outputs which is a link found in the readme.
I just re-read that section and it fails to mention that the fseq file needs to be "Sparse"
