Expanding My Displa...
 
Notifications
Clear all

Expanding My Display

4 Posts
4 Users
0 Reactions
900 Views
Posts: 41
Topic starter
(@mickisdaddy)
Trusted Member
Joined: 5 years ago
[#55899]

Ok this is my second year and I am planning on doing permanent lights on the house. Last year I did a mega tree and I have an Aplhapix classic controller running that. My plan was to purchase a HinksPix Pro setup or a Kulp. I was planning on putting the controller that runs the house lights in the garage and the tree is on the opposite end of the house. The problem that I am facing is if I were to run a cat5 cable from the garage where I would have the computer and router running the show to the controller on the mega tree it would have to cross the front walkway.

What would be the best way to do this? I don't mind swapping the controller on the tree with the one I am purchasing this year. I was thinking that so that I can run differential receivers off the Hinkspix or Kulp that I purchase this year.

This is probably part of the solution, but which of the two controllers would be best to help me solve

Thank you
Sean Wilhelm
My show is called Christmas on Elm Street


3 Replies
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Method 1 - wired. Find a way to get a comm cable from your garage to the other controller. If you are putting up permanent lights, perhaps there is a way you can put up a "permanent connection" along the house, as well.

Method 2 - wireless, with a caveat. For most applications, sending a full data stream via wireless could be problematic. There are many instances mentioned throughout all the sites of problems doing that. There are ways, but they require higher end equipment and you can read that as costly.

The caveat is using a main/remote(s) setup. With this only a sync signal is sent between the two players. Wifi can definitely handle this. There are many doing it.

Since the Kulp uses FPP natively, perhaps it could be your player in the yard with a FPP in the garage. Just a thought, and not a "do this" statement.


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

Personally, I now use the FPP Master/Remote method Al mentioned above to do this wirelessly. However, in the past when I was fully wired I used a "Step Conduit" to keep the wires out of the way and in place when crossing my steps. see the picture below.

Step Wire Conduit640

Reply
Posts: 128
(@sctwohig)
Estimable Member
Joined: 10 years ago

I would also suggest to look at going wireless with fpp master/remote configuration. FPP just sends sync packets wirelessly from your master fpp to all your remote fpp's. This also allows for additional future expansion. I have multiple remote fpp instances around the yard, out at the garage, and last year even expanded over in to my neighbors yard, and had 0 issues. Also using fpp eliminates the need to have a computer in your garage.

Thanks,
Shawn


Reply
Share: