Espixelstick SD pla...
 
Notifications
Clear all

Espixelstick SD playback

5 Posts
3 Users
0 Reactions
1,267 Views
Posts: 14
Topic starter
(@mikelu53)
Eminent Member
Joined: 7 years ago
[#56991]

I am running Espixelstick 4.4 on a ESPixelStick V3, I am playing a seq file from the SD card with 400 pixels, only one port. The problem is the sequence is about 5 min long, but the playback only shows about 30sec of it then restarts, then continues to replay.
I have tried different sequences and the same results, is there a ram limitation that's involved, I though readers were able to keep up without loading into RAM. This may be answered else where but I have not found it.
Thanks for any input.


4 Replies
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

Are you in remote mode or the standalone mode? Are you using the test function to play the sequence?


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

while the error is happening:
go to the admin page
select advanced mode
click home
the last fseq error will be added to the fpp status output, copy it to this chat


Reply
Posts: 14
Topic starter
(@mikelu53)
Eminent Member
Joined: 7 years ago

standalone, device and an SD card


Reply
Posts: 14
Topic starter
(@mikelu53)
Eminent Member
Joined: 7 years ago

I fixed it, had AP reboot selected and the Primary turned on. In the house WiFi signal was fine, but when I put the controller in the field it was not, and I guess it keep losing the signal and re-booting. I disabled the primary and de-selected the AP reboot.
So basically it wasn't in full standalone configuration.
I guess when the primary is enabled it can over ride the secondary setting, makes sense now.


Reply
Share: