ESPixelStick Flash ...
 
Notifications
Clear all

ESPixelStick Flash Tool

223 Posts
49 Users
0 Reactions
100.2 K Views
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago
Kev7274 wrote:Ok guys,I have two questions.

(1) Who is actually getting an IP address in the serial output and not a bunch of jibberish?
(2) PLEASE tell me what programmer you are using?:wink:

Kind of annoying that I have to look into my router to see what IP address the modules are getting. I'm using the programmer and flashmaster from dirk.

Hi Kev, the ESP is a bit unusual as it uses two or more baud rates and it is expected that you will get some ‘gibberish’ over the serial. You should be looking for useful communication @ 115200 for coms from the ESPixelStick as opposed to the boot information from the ESP which @ 74880 will appear as ‘gibberish’ at 115200.


Reply
shanicus
Posts: 266
(@shanicus)
Reputable Member
Joined: 14 years ago

I've actually successfully used the Parallax Prop plug to program the boards to load V2. With an external power supply for the ESPIXEL Stick.

Not sure about the "jibberish" messages from the serial output. Though out of the four ESPIXEL's I did have one "dud" that just wouldn't take an upload from any programmer.


Reply
Posts: 20
(@mstevica)
Eminent Member
Joined: 16 years ago
Untitled

I do not know where I'm wrong.
When programming esp just blinking blue LED.
No WiFi only blinks blue LED.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago
mstevica wrote:

I do not know where I'm wrong.
When programming esp just blinking blue LED.
No WiFi only blinks blue LED.

The SSID and Passphrase are missing. Did you not include, or erased before posting.

These are required


Reply
Posts: 95
(@atxc5)
Estimable Member
Joined: 16 years ago

I used the Flash Tool to upload all of my ESPPixelSticks and GECE boards. The GECE's are working good but I am having heck with the ESPPixelSticks controlling WS2812b strips. Turning the entire strip ON seems to work very well. When I start doing chase sequences, random pixels light up sporadically. After researching this issue, I found posts that indicate setting the ESP8266 CPU speed to 160 Mhz instead of the default of 80 Mhz. Does the flash tool set the CPU frequency?


Reply
Page 13 / 45
Share: