stampedeboss wrote:I keep getting Error 10 message and no upgrade.
I'd try download the .EFU zip again. That's a corrupt magic byte on the bin portion of the update.
mlevings wrote:Any chance of getting a reverse option on the pixel output? I have a few places I could use these and a reverse output would be much easier than repatching my sequences.
I'll add it to my list of things to look at for next year.
atxc5 wrote:I used the Flash Tool to upload all of my ESPPixelSticks and GECE boards. The GECE's are working good but I am having heck with the ESPPixelSticks controlling WS2812b strips. Turning the entire strip ON seems to work very well. When I start doing chase sequences, random pixels light up sporadically. After researching this issue, I found posts that indicate setting the ESP8266 CPU speed to 160 Mhz instead of the default of 80 Mhz. Does the flash tool set the CPU frequency?
Are you on 2.0 of the firmware? If so, try this 2.1-dev update that has relaxed timing on ws2811 for some clone 2811 chips that people have been receiving this year. It's located here - http://diychristmas.org/vb1/showthread.php?6663-ESP-association-problems&p=78775&viewfull=1#post78775 . The binary which the flash tool uses sets the CPU to 160 MHz for you.
For those having issues getting serial output from the programming tool:
- Try swapping the programming jumpers around. I've had reports from a few people that received flaky jumpers with their programmers.
- If you still fail to get legible output in the serial output section after programming, do the following:
* Exit the programming tool and download PuTTY.
* Select serial for connection type, 115200 for the baudrate, and using the same COM port you used in the programming tool.
* Manually reset the ESPixelStick by clicking the reset button on the board.
* You should know see startup information along with the assigned IP.
all just a test and will not.
all day and I sweat me neide.
only if it is not a problem around the usb port of the controller.
what settings go here?



