ESPixelPops and fli...
 
Notifications
Clear all

ESPixelPops and flicker issues

15 Posts
9 Users
0 Reactions
2,838 Views
Posts: 10
(@kchristmas75)
Active Member
Joined: 8 years ago

Not sure if this helps any buy I had some strange issues happen like that a couple days ago while testing an SD Card with ESPixelStick 4.0. I'm using a ESPixNode. When my NodeMCU board is plugged directly into the ESPixNode, everything works perfectly. For the SD Card test, I used breadboard wires to hook everything up for testing. There was lots of flickering even when not running any sequences. With sequences running, colors were wrong and flickering. I thought I had a bad wire so I gave everything a wiggle but all looked good. What I did notice was every time I put my hands near the wires both with and without touching them, the pixels would change colors and flicker differently. Best I can figure is the wires are picking up interference from something. Maybe the esp8266 itself, maybe the power supply. Not 100% sure. When I twisted the wires together, the flickering stopped almost entirely and the sequences looked correct but the colors were all off. Blue was pink, red was green, etc.

I then decided to try with an ESP32 Dev board. The pinouts are different and are spaced differently so I had to use breadboard wires again. Same interference issue with the ESP32.

Finally, I just plugged the NodeMCU back in to the ESPixNode and soldered wires from it to the SD Card. Works perfectly so I'm leaving it as it.


Reply
Posts: 7
Topic starter
(@jfunk138)
Active Member
Joined: 6 years ago

At this point I'm even more convinced temperature is a factor here. Unseasonably warm night in New England and not a flicker in sight. What component on the pixel pop board has a temperature dependency like this?


Reply
Posts: 119
(@packetbob)
Estimable Member
Joined: 17 years ago

Try a different ESP-01 module...
They are built pretty cheaply so you could easily have a flakey one (or two...)
Could also be the 2N7000 MOSFET used as the level translator...
Nothing else really touches the signal to the pixel....


Reply
Posts: 119
(@packetbob)
Estimable Member
Joined: 17 years ago

And try a different power supply...


Reply
Posts: 52
(@davwav02)
Trusted Member
Joined: 13 years ago

I had similar issues when I started using pixels last year. Here's the post where I tried to thoroughly document my troubleshooting steps.

I think that I concluded that adding the 5V voltage regulator (IC1) to my Pixel Pops boards, even though I wasn't using 12V pixels, seemed to resolve the issue. (I'm not an engineer or anything, so I can't say why that seemed to work, but I haven't had any flickering issues since including the 5V regulator on all my boards.)

As a separate note, I too started off running everything from PC power supplies, being an IT guy with plenty of them around. After one or two of them started getting finicky and one just up and quit, I switched over to LED Drivers and have not had any power supply issues since. I still run one window off a PC power supply with no issues because it's been easier than running a long cable, but everything else in my display is powered by LED drivers. On the indoor power supplies, I just attached everything to the terminals, and on the outdoor ones, I opened up the power supply and replaced the wires with my preferred connectors.

I was where you are with the flickering pixel last year, and it was unbelievable frustrating. I hope this helps.


Reply
Page 2 / 3
Share: