ESPixelPops and fli...
 
Notifications
Clear all

ESPixelPops and flicker issues

15 Posts
9 Users
0 Reactions
2,830 Views
Posts: 7
Topic starter
(@jfunk138)
Active Member
Joined: 6 years ago
[#55225]

I'm having some trouble tracking down a flicker issue with my ESPixelPops. Here's the setup:

HP power supply -> 10 ft. 16 gauge wire -> ESPixelPop -> 18 inch xconnect pigtail -> first pixel of string

I get random red, green, and blue flickering at idle of various pixels in the string. Even after sending a static color to the controller, I still see random flickers. The problem is more severe immediately after power up (5 flickers per second) and happens after its been powered on for a few minutes. Still about one flicker every few seconds.

Any ideas what is going on?


14 Replies
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Does pixel 1 also flicker?


Reply
Posts: 7
Topic starter
(@jfunk138)
Active Member
Joined: 6 years ago

The flickering is random blinks of single lights. I watched the string of 50 for about 5 minutes and didn't see "pixel 1" flicker during this time. Other random pixels were randomly flashing at a rate of about 1 every 2 seconds.

Another strange observation... After this 5 minute test, I unplugged the power supply and then plugged it back in. No flickering at all now. I'm going to unplug for a longer time and then replug and will report back with results.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

it really sounds like data and v- from the controller to the first pixel is not good.


Reply
Posts: 7
Topic starter
(@jfunk138)
Active Member
Joined: 6 years ago
MartinMueller2003 wrote:it really sounds like data and v- from the controller to the first pixel is not good.

Agree, I've looked at this. It's a single 18 inch pigtail from the controller terminal block to the first pixel. I've swapped for another pigtail, same issue.

After many cycles now, the temperature definitely seems to be a factor. Once it's heated up inside the problem is virtually gone. Outside in the cold, it seems to stick around...


Reply
Page 1 / 3
Share: