ESPixel Pop Tiny In...
 
Notifications
Clear all

ESPixel Pop Tiny Injection

12 Posts
5 Users
0 Reactions
2,854 Views
Posts: 40
Topic starter
(@gpoduska)
Trusted Member
Joined: 13 years ago
[#49699]

I am trying to figure out what the best configuration is to install the ESPixel POP Tiny. Which is preferred? A or B in the pic? Power will also be injected at 7 other points on a 700 pixel matrix, but I am interested in the first injection.

espixelpopinjection

11 Replies
Posts: 144
(@drewdennis)
Estimable Member
Joined: 9 years ago

Me personally...I'd go with B.


Reply
Posts: 42
(@markp)
Eminent Member
Joined: 15 years ago

There's no fuse on the pop tiny, so I'd use Option B and fuse the supply to the strip separately to the board. It also means any injection you do further down the strip will have the same configuration - just link the GND and connect another 5v supply.


Reply
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

+1 on the B vote


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

"B" except fuse both ESP and Pixels. Let the fuse blow before you burn the house down. Too many installers omit fusing due to the cost of being lazy. Don't let cost or laziness take your home.

"A" also works if your load is light - 1 or 2 strings/reels - but fuse here too


Reply
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

Good point.
You can get a fuse with an inline holder from Tayda for about 25 cents!

mrGrumpy wrote:B except fuse both ESP and Pixels. Let the fuse blow before you burn the house down. Too many installers omit fusing due to the cost of being lazy. Don't let cost or laziness take your home.

Reply
Posts: 40
Topic starter
(@gpoduska)
Trusted Member
Joined: 13 years ago

Thx for all the help... I am going with "B" as this is a 700 pixel matrix 14 x 50 and injecting every 100 pix. im using a 5v 20A PS.. so does this mean i should use a 20A fuse?


Reply
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

I don't think so.
Each pixel draws 60ma or 0.060A full on.
So... 100 * .060A = 6 amp.
It seems to me at each injection point you would use a 6 amp fuse.
Also, your power supply doesn't seem beefy enough.
I think you will need 42amps at max power. You can probably get away with a 40A supply.

gpoduska wrote:Thx for all the help... I am going with "B" as this is a 700 pixel matrix 14 x 50 and injecting every 100 pix. im using a 5v 20A PS.. so does this mean i should use a 20A fuse?

Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

I say no, fuse for your wire size. But that is a whole new issue that most don't follow.


Reply
Posts: 40
Topic starter
(@gpoduska)
Trusted Member
Joined: 13 years ago

So like this from the wiki? Im using 18awg for injection.. So 6A fuses between PS and controller and controller and strips?


Reply
Page 1 / 2
Share: