I've got a few, they're OK, not had any issues.
So how is having a non-isolated splitter any different or any more risky than having everything daisy chained? It's a very good point - it's no diff...
It's not a necessity to have isolation, but obviously it's at your own risk - a fault in one zone could potentially knock out all the others. Your s...
I built a 4 channel with an Arduino and DMX shield. Even with OLED screen it still worked out cheap and works great.
That's exactly how it would be done now - the pixels are so cheap that it's now affordable. Back when the thread started 8 years ago they weren't so c...
I've never used different connectors for solid/stranded Cat5e, think you'll be fine with whatever you've got
PuppyBoy wrote:Any chance getting some help on servo position . When I start vixen the servos will go right to 0 position (val1, 0, 255, 0, 180) . If ...
Screwfix 65426 also works - I've used lots of it for making pipes with 40mm end caps and strips inside. Have tried to form an arch but it springs bac...
EricGunnerson wrote:Cool. I'd suggest ordering a single board to verify that it will work correctly for you before doing more. I’m sure they will wo...
Could you place them on a shelf on a top-floor window sill to make them more accessible, instead of the roof? I've rigged one up on a stand before (an...
I've signed up for stock notification on Tindie - would be ideal for converting some of my floods, thanks!
It'll drive 170 pixels if you've got it in DMX mode (max = 512 channels, 510 divided by 3 RGB channels = 170). Otherwise if it's directly driving the ...
That's definitely one way to cause a higher number of pixel failures! I saw one being demonstrated on a stage once and it wiped out some expensive AV ...
Could it be a power issue with the E682? You shouldn't be anywhere near the limit of the PSU but might be worth swapping it out to see if it makes any...
