Finally Affortable ...
 
Notifications
Clear all

Finally Affortable Snowfall Tubes (FAST)

448 Posts
68 Users
0 Reactions
262.9 K Views
Posts: 691
(@stormyblade)
Honorable Member
Joined: 12 years ago
chelmuth wrote: http://led.linear1.org/1led.wiz

This is a calculator for led resistor values just plug in the forward voltage for the led and the source of 5v and bam. If you were wanting to use multiple colors on a single tube I would just use the highest resistor calculated the other colors will be dimmer but most likely not noticeable.

I realized I went back and read your reply and forgot to say thanks for this. I've already ordered my resistors (turns out for amber, green, and purple, I need 100 ohm and 180 ohm). So glad I asked about this and didn't just order the standard BOM list.


Reply
chelmuth
Posts: 1077
Topic starter
(@chelmuth)
Noble Member
Joined: 16 years ago

Anytime.. I might not be around much anymore but I still get emailed about threads I was attached to so I'm always lurking.


Reply
Posts: 19
(@samckitt)
Eminent Member
Joined: 10 years ago

I have not read thru the whole thread, so don't castrate me if this has been discussed. Also, I am not an electrical engineer, but was thinking something.....

These little Arduino boards are pretty cheap & can program them to do just about anything, so I was thinking what if a PCB for the snowfall tubes was made to allow one to be soldered to it & it can controll a string of those NEOPIXELS that can be addressed individually, & can be set to any color. Also what if the board was made in such a way that the LED can be seen from either side? And make another board that can be added to the end of another to increase the length. The Arduino can be programmed to whatever number of LEDs you have by changing one line in the code.

36" length:

Connector (all controlled through 4 traces):

Digispark development board: (less than $2 each)

Then the other thing I would like to find, is an e17/C9 socked with a transformer circuit built in to drop it down the 5v. Then I'd get a C9 string, put some flashing white LEDs in some sockets, some constant burning ones in others & these snowfall tubes in others......


Reply
Posts: 42
(@markp)
Eminent Member
Joined: 15 years ago

That's exactly how it would be done now - the pixels are so cheap that it's now affordable. Back when the thread started 8 years ago they weren't so common!


Reply
Posts: 602
Guest
(@bwinter)
Honorable Member
Joined: 10 years ago

There are many other ways this can be done now:

https://youtu.be/D-OxLoW3gYE


Reply
Page 89 / 90
Share: