Hey, it's been a couple years since I built my FAST tubes and they are still going strong. I was asked, however, if I could build FAST tubes for Halloween, just for some added color. Now, the question is, what changes, if any, do you need to make to the resistor values, if you use different colors than the white that the Wiki calls for?
https://www.doityourselfchristmas.com/wiki/index.php?title=FAST_Finally_Affordable_Snowfall_Tube From the BOM section: "In addition, you will need up to 56 White Piranha Style Super flux LEDs. Other colors could be used, but you may need to adjust the resistor values on the controller board." In my case, I was asked to do green, amber(orange), and purple -- all using Piranha Super flux LEDs. Is there some calculations I need to know about to see if I have to change the resistors?
http://led.linear1.org/1led.wiz
This is a calculator for led resistor values just plug in the forward voltage for the led and the source of 5v and bam. If you were wanting to use multiple colors on a single tube I would just use the highest resistor calculated the other colors will be dimmer but most likely not noticeable.
chelmuth wrote: http://led.linear1.org/1led.wizThis is a calculator for led resistor values just plug in the forward voltage for the led and the source of 5v and bam. If you were wanting to use multiple colors on a single tube I would just use the highest resistor calculated the other colors will be dimmer but most likely not noticeable.
WOOOOOAH! Welcome back!! Previous post was "10-02-2015, 07:31 AM"!!!
Shhhhhhhh. ................ you might scare him away again .......... lol, good to see you back!
Sent from my SM-G930V using Tapatalk
Impressive !!!
Very good!
