in the model, do i need to set the controller to dmx and a channel number?
Ok, I think the missing piece is putting the AP in bridge mode vs router mode, correct? That way everything is on the same subnet... regardless of in...
So you are recommending this? Master and Remote on same net... AP connected to home router if i want that, or connect to it via wifi too for updates ...
I want to keep it completely off of my home network and run the sequence from sd card on the FPP locally. To access the FPPs for changes or uploads, ...
If you have an arduino and breadboard laying around, this is all you need !! Simply connect the leads, load the sketch and run the program on your PC...
Is is possible to power inject with 2 separate PSs on a F4v3. I know the F16v3 has 2 power banks. I would like to have 2 ports of LEDs, each with it...
So, to find cheap plugs from old light strands, I went to Dollar Tree and found $1 light strands that I cannibalized for the plug and wire..!
Here's what I came up with on my 3D Printer... big pill bottle'ish container... Screw on lid. I have it chopped in 2 since my printer wont go that hi...
Maybe a large toothbrush holder?? Maybe a remix of this: ???
I bought a $1 punch bowl from the dollar store.... made holes and inverted for 180 deg globe... Controlled via pixelstick.. Works great!
If you have an arduino and a breadboard, I was able to program 4 chips in 5 minutes with this setup... Simply connect 5 wires and upload the sketch. ...
This is exactly what I had in mind... 350/350.. Will let you know how it goes once i add it!
