FPP Master/Remote N...
 
Notifications
Clear all

FPP Master/Remote Network

6 Posts
2 Users
0 Reactions
8,075 Views
Posts: 40
Topic starter
(@gpoduska)
Trusted Member
Joined: 13 years ago
[#51276]

I'm looking to confirm my network setup in regards to the FPP Master/Remote config. Is it ok to have the Master communicate via Wifi to the AP and the Remote communicate to the AP via Ethernet. My AP is a UB Loco M2. I want to make sure the sync packets dont have to be on the same network/media.

Xmas2019

5 Replies
Posts: 40
Topic starter
(@gpoduska)
Trusted Member
Joined: 13 years ago

I want to keep it completely off of my home network and run the sequence from sd card on the FPP locally. To access the FPPs for changes or uploads, I simply connect to the AP from my home computer (I dont need to make many changes). From what I understand the sync traffic between master and remote is nominal. My question is using master to communicate with remove via wifi and ethernet (I assuming the AP will handle any routing).


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

The master and slave need to be on the same network. Depending on how you configure the AP, The wired and wireless would be the same network. The drawback is a slight delay incurred on the wireless side that may cause the slave to be a bit behind.


Reply
Posts: 40
Topic starter
(@gpoduska)
Trusted Member
Joined: 13 years ago

So you are recommending this? Master and Remote on same net... AP connected to home router if i want that, or connect to it via wifi too for updates and uploading sequences...

Xmas2019

Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Your picture shows everything on different networks. Assuming you are using a 192.168 net. All of the addresses would start with the same three numbers: 192.168.40.??? giving you 255 devices on the 192.168.40 subnet. Then everything will work and be seperate from your house network.


Reply
Page 1 / 2
Share: