E682 wiring help
 
Notifications
Clear all

E682 wiring help

22 Posts
9 Users
0 Reactions
8,103 Views
Posts: 149
Topic starter
(@bob81354)
Estimable Member
Joined: 15 years ago

Hi to all
Ok I think I found problem


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Well - knew it was a short but wasn't expecting that! Diodes tend to open vs short so that is quite odd but definitely would explain the issue. That diode is there for reverse wiring protection. If you wired up the + and - backwards, it would only allow .6v or so across the pixel power terminals (reversed polarity) limiting the damage (hopefully). As-is, without the diode you should be able to wire both power inputs up and it should work fine now. The diode is not required for operation - just to prevent an oopsie...

If you are careful with your power wiring on J18 you can test the entire board now while you wait for the replacement diode.


Reply
Page 3 / 3
Share: