E682 wiring help
 
Notifications
Clear all

E682 wiring help

22 Posts
9 Users
0 Reactions
8,100 Views
Posts: 149
Topic starter
(@bob81354)
Estimable Member
Joined: 15 years ago
[#37340]

HI TO ALL

I am trying to get my E682 running on both sides but it’s not working I tried hooking it up both ways one with the wire going straight to J18 to power + - then tried jumping from J19 + to J18 + I get power to 3&4 side when I put power to J19 what am I missing? Here are some pics

Thanks Bob

IMG 25081
IMG 25051
IMG 25131
IMG 25111

21 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

You must provide power to J19 always - it provides power to the logic of the board itself. Be sure your jumpers are correct to accept 12v pixel power. The connection to J18 by itself will not work. J18 provides the power to connectors 1-x and 2-x, while J19 provides the power to connectors 3-x and 4-x as well as the logic.


Reply
Posts: 149
Topic starter
(@bob81354)
Estimable Member
Joined: 15 years ago

when I put power to j19 It powers up but I when I jumper j19 to j18 I get nothing and when I power to j19 I can run pixels on3&4 I have looked for bad solder joints but I can't see any


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Gotta ask -- are you sure you have the correct polarity going to J18 from J19? Sounds like you are shorting them?


Reply
Posts: 149
Topic starter
(@bob81354)
Estimable Member
Joined: 15 years ago

yes


Reply
Posts: 149
Topic starter
(@bob81354)
Estimable Member
Joined: 15 years ago

yes I check. and re checked


Reply
Posts: 1133
(@toozie21)
Noble Member
Joined: 19 years ago

Are your voltage jumpers in the upper right corner of the board configured properly?

Short and badly typed since written from my phone...


Reply
critic2
Posts: 1389
(@critic2)
Noble Member
Joined: 17 years ago

Is the power supply set for 110v input? (110/220 settings)
Clean the solder rosin off the board. A clean board is a happy board.
As Brian mentioned, verify the polarity of your DC voltage wiring. When using the same colored wires for V+ and V- try to color code them to avoid mix up. Phase tape, marker, paint, etc.

Also, try to always use a 3 wire AC power cord with power supplies. The equipment ground is a very important conductor when it comes to safety.


Reply
JCook
Posts: 1003
(@jcook)
Noble Member
Joined: 13 years ago

Check for 12v at J19 then check the 3.3 vdc regulator that you have 3 vdc. Did you check to see if the LEDs worked before you installed all of the ICs? This was a step in the instructions. When you connect power to J19 and not J18, 2 of the yellow LED will be on. The bottom one only comes on when J18 has power.

Jay


Reply
Posts: 149
Topic starter
(@bob81354)
Estimable Member
Joined: 15 years ago

ok I shot some video so you can see what's going on and looked on the back of the board and did not see any bad solder joints

Thanks Bob


Reply
Page 1 / 3
Share: