e682 numbers help
 
Notifications
Clear all

e682 numbers help

23 Posts
7 Users
0 Reactions
5,357 Views
jlowe
Posts: 952
(@jlowe)
Noble Member
Joined: 16 years ago

Is this a strip of pixels? Agree with the earlier post about power injection concerns with a length of 150 pixels.

Also, are you sure that the pixels are 12v?

And, did you solder the wires on to the end? Are you sure that all the solder connections are good?


Reply
Posts: 13
Topic starter
(@jmaverick101)
Eminent Member
Joined: 10 years ago

Pretty sure they are 12V. These are the WenTop from Amazon. As far as power injection don't I only need that if I need to run all 150+ lights at 100 percent load. Am I supposed to solder the ends to on wires? I just cut screwed in.

Been looking at my jumper wires. Anyone know what J22 is for, I seem to be missing a connector.


Reply
Posts: 1120
(@4586shaggy)
Noble Member
Joined: 14 years ago
jmaverick101 wrote:Pretty sure they are 12V. These are the WenTop from Amazon. As far as power injection don't I only need that if I need to run all 150+ lights at 100 percent load. Am I supposed to solder the ends to on wires? I just cut screwed in.

Been looking at my jumper wires. Anyone know what J22 is for, I seem to be missing a connector.

You do have to strip the ends of the wire first then put them in the terminal and screw down.

Sent from my iPhone using Tapatalk


Reply
scott4864
Posts: 124
(@scott4864)
Estimable Member
Joined: 17 years ago

I don't see any IC chips on the ribbon in the picture. It may not be smart pixels.

It could be a strip of dumb pixels where the entire strip is the same color. If that is the case they will not work with that controller.


Reply
Posts: 1120
(@4586shaggy)
Noble Member
Joined: 14 years ago

Could you take a picture of the actual strips for us? There should be a little black square before the actual led's, that's what we are looking for

Sent from my iPhone using Tapatalk


Reply
Page 3 / 5
Share: