So I have my E682 and have, in the past, powered 10 of the ColorEffects strings, but I would connect them all directly to the board with no extension of any sort. That isn't the best way to try and do any worthwhile layout, so I started making some extensions. Just for testing, I made an extension 100' long. It mostly works! But, when all the lights are on, the ones near the end seem a little dim. Plus I noticed that some of the strands that weren't connected with an extension started 'mis-firing' by twinkling or becoming the wrong color for a split second. This is with only 5 strands connected.
So I suspect I need to push more juice down the lines but not sure the best way to do it. I Currently have a MeanWell SE-350-5 powering everything.
Any ideas if there is a better power supply or if there is something else I may try to ensure I can connect all 16 strings and have them work proper?
Thanks in advance,
Brian
You can try what I did. I'm running 5 volt pixels but using a 12 volt supply. I used buck converters at each 50 pixel string. 100 feet is a lot to ask to run 5 volts. You're definitely losing power near the end.
Sent from my SM-T710 using Tapatalk
Is that 5 strands of 10 lights each?
Sent from my SM-T710 using Tapatalk
No it is 5 strands of 50 lights each.
All on one line
Sent from my SM-T710 using Tapatalk
Are you using 5 outputs on the 682?
Sent from my SM-T710 using Tapatalk
Also, how far from the controller is the first pixel?
Sent from my SM-T710 using Tapatalk
I could be wrong but I don't think the 682 will work on these.
Sent from my SM-T710 using Tapatalk
It works fine. I've been using them for several years. This is just the first time I want to add extensions and equip all 16 outputs.
The extensions are so I can have variable distances from the controller.
