e682 numbers help
 
Notifications
Clear all

e682 numbers help

23 Posts
7 Users
0 Reactions
5,369 Views
Posts: 1159
(@deonb)
Noble Member
Joined: 13 years ago
jmaverick101 wrote:Pretty sure they are 12V. These are the WenTop from Amazon. As far as power injection don't I only need that if I need to run all 150+ lights at 100 percent load.

Even at 66% load (e.g Cyan, Magenta or Yellow) you'll see a hue shift at the end of that many pixels.

jmaverick101 wrote:Anyone know what J22 is for, I seem to be missing a connector.

J22 is a set of shunt positions - you put a shunt on any or all of them if you want a group (e.g. 1-x) to output with balanced output (-5V/5V) instead of TTL (0V/5V). It's generally used if you use DMX props - not for most pixels. Each shunt position controls the setting for a group of 4 ports.


Reply
jlowe
Posts: 952
(@jlowe)
Noble Member
Joined: 16 years ago

These are all great things to check. And, in addition to a picture, could you post the Amazon link to exactly what you purchased? I searched wentop, but that's quite a bit of options.


Reply
Posts: 13
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

I noticed you have a Pi in the setup. Are you sure FPP is setup correctly?

Sent from my SM-T710 using Tapatalk


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Your exported sequence from Vixen will have different network settings for FPP. I found out thanks to someone logging into my computer and showing me what I did wrong. Vixen exports a network file. FPP needs to reflect those settings in the order of the network file.

Sent from my SM-T710 using Tapatalk


Reply
Page 4 / 5
Share: