I'm pretty sure I can guess the answer here, but worth confirming. I was under the impression you could do the first 7 universes on the e682 as any of the supported formats, including multicast, but that from the 8th universe and up, you couldn't use multicast, had to be unicast or other. For some reason, and the way it's labeled, I thought I could have my first 7 universes on multicast, and then switch to unicast for 8-12. More or less just setup a different controller as unicast that has universe 8-12, and have the multicast controller end after 7. I set it up this way in vixen, played back, and realized I was missing almost the entire show. That's when I noticed the drop down box ONLY has the unicast and multicast receiving mode as a set choice for the entire controller if I'm correct. You can't have it be one for part, and one for the other (which is really not that crazy when you consider it can handle 5v and 12 v pixels from the same controller at the same time, and use 4 different types of pixels on the controller outputs at the same time. So if I need to go into the 11-12 universe territory, am I basically stuck doing unicast for the entire controller? I actually had always only used unicast previously, but I came across multiple detailed explanations as to why multicast was much preferred. A note, I'll be using probably 11-12 universes through the e682 connected directly to my pc Lan port. But I am also adding some wemos d1 mini's this year for wireless e131 testing. I had just planned on having the router wirelessly connected to the laptop in the other room over it's wifi network (provided the connection is decent), and having the wemos sticks (3 of them) picking up that same wifi network. Does this sound feasible with this setup? Or would I have to connect the laptop via lan cable to the router, and the e682 also connected via lan cable, and the wemos devices devices picking up the signal?
Yes, as you figured out, the e682 can only be set in either multicast or in unicast mode, not mixed.
Your show player should not use Wireless to send data. You want to use a wired connection to an access point to then send to the Wireless controllers. So yes you want to use a switch to connect you laptop, e682, and access point (AP). For testing an old wireless router (which can also act as the switch) is fine, but you would need to get a dedicated AP such as the Ubiquity Nanostation Loco M2 for running your show.
Sent from my ASUS_A009 using Tapatalk
