E682 flickering pix...
 
Notifications
Clear all

E682 flickering pixels

12 Posts
6 Users
0 Reactions
4,478 Views
Posts: 528
Topic starter
(@bud29)
Honorable Member
Joined: 17 years ago

Yes, random and real quick all over. Distance between first pixel to controller is only about 5 feet.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

How many wires are going from the controller to the first pixel? What are they?


Reply
Posts: 528
Topic starter
(@bud29)
Honorable Member
Joined: 17 years ago

Just +12V, data and gnd. Just using the standard connectors from DIYLedexpress.


Reply
Posts: 241
(@mrdudeman)
Reputable Member
Joined: 12 years ago

i would guess your data wire is losing voltage... but you only have 5 feet between controller and first pixel - that should work fine... so then that leaves us with wire gauge too small...

1) if you set testpattern to all white are they white or pink near the end?
2) what gauge wire goes between controller and first pixel?
3) same gauge for DataWire as for gnd and 12V ???


Reply
Posts: 528
Topic starter
(@bud29)
Honorable Member
Joined: 17 years ago

I'm thinking it's the firmware thing. This string works perfect on a bridge/pixel extender setup with the exact same cables and wire lengths. I've checked all the connections and they look good. And it works perfect in every test mode on the e682, it only starts screwing up when the output is off(test mode 0)


Reply
Page 2 / 3
Share: