I was wondering if there will ever be an update to the Sandevices e682 that allows for a gateway so that when the e682 is on a different network for a show that it can be accessed and updated without having to plug a computer into that network. I am trying to run a show from a pi with its own network so not to bog down my home network.
In FPP you can setup proxies to other devices on the same network as FPP. Once setup you connect to FPP them launch the connection the Sandevice
All you need to do is:
-setup wifi connection on pi so it connects to your home network
-by default the pi will use the lan interface (cable) for the show network.
-set the checkbox for interface routing (think it is called Enable routing between network interfaces). This is on network configuration in FPP.
Now for the "tricky" part....
You have to set your gateway to point to the Pi, so it can route the traffic where it needs to go.
All this entails is opening your network connection (on your computer)
-go to network and sharing center and click Change Adapter settings.
-From here, right click your NIC (wired or wifi) and select properties.
-Left click on Internet Protocol Version 4 and click Properties.
-Select the USE THE FOLLOWING IP ADDRESS radio button.
-In the IP address field put in an IP on your home network not in use. (you can open a command prompt and type ipconfig and use the one given by DHCP).
-Hit TAB and Subnet mask will fill in with 255.0.0.0.
-Hit Tab again and in the default gateway put in the IP of your pi.
Click OK and OK.
Now you should be able to open a browser and put in IP of your E682.
When done, just reverse the changes to your NIC but you can leave the check box on the pi for routing (will do no harm).
Of course this all assumes you have 2 different subnets assigned for the show network and your home network.
In my case my home is on 10.252.X.X and the pi is on 192.168.X.X
I did something very similar to what DrNeutron described, only I did it in my router. I was amazed -- as long as my Rasp Pi is plugged into the show network (I've got a unmanaged network switch) and everything is powered on, I can reach out to any of my devices as if they were sitting right next to me. Even if they are on a separate network than my home network. Yesterday afternoon I was able to use my tablet to access my E682 and check some settings...holy schmokes life just got a little easier. :blink:

