Does it flicker all the time, or is it one color , i.e. white that causes the flicker?
thevikester wrote:Does it flicker all the time, or is it one color , i.e. white that causes the flicker?
Its no so much a "flicker" as it is a constant quick blink approximately every second. Almost like a constant pulse, not acting like there is water in the strand. Also I noticed that it is more prominate in the third cluster. When I run one of the test patterns from the configure page I do not see the "pulse" ie constant on red, green, blue, etc. The controller was working fine up to about a week ago. I'm using LSP. I see it on all of my sequences. I even tried running the sequences from two different computers with the same results. Tried swapping out ethernet cables also but still cannot figure out why I'm seeing the "pulse/blink" The "pulse/blink" is more noticable when the pixels are white.
I may have a similar issue but I am using E6804s. On one output of one of the boards, sometimes, I would see a quick all-white on effect kind of "play" under the main sequence effect (which is a very slow color to color fade). This all-white on effect only appears for a split millisecond. Strange thing is that this doesn't happen all the time. It looks like a data wire issue or something. I tried to do some quick field diagnostics to re-seat and move around the lead cable and it seems to help at first, but then came back. It would be easier to diagnose if it constantly happens, but it seems to occur some nights, then work fine other nights. I suspect a bad connection in the pigtail connectors somewhere.
I finally figured out my issue. The "Timeout" value in my E682 configuration was set to 1 instead of 0. Once set back to 0 the pulse/flicker is gone. Of course I discover this after the Holidays.
