E682 Controller Pro...
 
Notifications
Clear all

E682 Controller Problem with one socket causing flicker

9 Posts
7 Users
0 Reactions
2,721 Views
Posts: 43
Topic starter
(@dicklinn)
Eminent Member
Joined: 14 years ago
[#35126]

Using two of the E682 controllers on a mega tree, 50 pixel strings on each plug, 2811 pixels. On one controller, I have 4 outputs acting strange. A slight bit of flicker on the first 4 outputs (socket 1) and pixel 50 does not light. All other outputs are working perfectly. Have done all the trouble shooting on connections, power supply, voltages, cables, everything I can think of. I'm guessing perhaps a chip is bad? Things had been working perfectly for a few weeks.

Any help would be greatly appreciated. My mega tree isn't quite as merry!

Thanks,
Dick Linn


8 Replies
kayjay
Posts: 88
(@kayjay)
Estimable Member
Joined: 16 years ago

I was wondering if anyone ever responded to you. I'm seeing the same issue.


Reply
Posts: 1115
(@11bravo)
Noble Member
Joined: 14 years ago

If you have experienced rain, water my may have got in the connection or in the pixel itself. Happened to me.


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

Check the resistor pack near the outputs. If they are not making proper contact then it may cause some flickering. I had the same problem.


Reply
Posts: 482
(@jcmarksafb)
Honorable Member
Joined: 15 years ago

Try swapping out the 20 pin IC's on the board, the ones that you can lift out of the sockets. Find one that is good and swap it out for the 1st cluster. I have had a couple of those go bad. I ordered these and they replace the bad ones. http://www.ebay.com/itm/QTY-10-SN74HCT541N-TI-20-PIN-DIP-PACKAGE-OCTAL-BUFFER-FREE-SHIPPING-74HCT541-/121124605666?pt=LH_DefaultDomain_0&hash=item1c3396cee2
John


Reply
Page 1 / 2
Share: