E681 Assembly Mista...
 
Notifications
Clear all

E681 Assembly Mistake

10 Posts
5 Users
0 Reactions
6,131 Views
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Well - - I originally had some of my GECE's running from my E680 which has no buffering or resistors at all and they ran fine - so I would assume that a jumper/0 ohm may work for those as well but I guess Jim should supply the final answer.


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago
I still would like to know what the proper network is for GECEs. I've looked through all of the PDFs available on sandevices.com, I've looked on the DIYC wiki, as well as done forum searches, and I haven't found anything about those other than they need to be switched for certain configurations and they're required.

In the 'DMX' forum there is a thread titled 'E681 to pixel cable length' (13th one down at the moment)
Post #22 will give you more info.


Reply
Materdaddy
Posts: 2368
Topic starter
(@materdaddy)
Famed Member
Joined: 16 years ago
Barnabybear wrote:In the 'DMX' forum there is a thread titled 'E681 to pixel cable length' (13th one down at the moment)
Post #22 will give you more info.

Thank you. I missed that thread.

For future reference, here's a direct link to post 22: http://doityourselfchristmas.com/forums/showthread.php?19078-E681-to-pixel-cable-length&p=192393#post192393


Reply
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

I've reworked a lot of boards over the years and I've found it best to cut the leads on the part being removed then remove the leads from the top. It's much less likely you'll damage the board because the heat won't be dissipated by the part.

Sent from my iPad using Tapatalk


Reply
Materdaddy
Posts: 2368
Topic starter
(@materdaddy)
Famed Member
Joined: 16 years ago
timon wrote:I've reworked a lot of boards over the years and I've found it best to cut the leads on the part being removed then remove the leads from the top. It's much less likely you'll damage the board because the heat won't be dissipated by the part.

Thanks for the advice. I would have done that (since I sacrificed the part anyways) but there was no tool I posses that could clip the leads from those with the other components around it. I used a 3 step process. 1. "huge blob of solder" trick to get the actual part out; 2. Heat the solder and smack the board on the table trick to get the majority of solder out; 3. Solder sucker to pull the remaining solder out of the hole. This ended up removing one pad not from the suction, but from the sticky mess of flux from step 1. I need to buy some flux cleaner with as messy as that made the board.


Reply
Page 2 / 2
Share: