WS2811 pixel compat...
 
Notifications
Clear all

WS2811 pixel compatibility

26 Posts
9 Users
0 Reactions
65.4 K Views
Posts: 1249
Topic starter
(@jstjohnz)
Noble Member
Joined: 17 years ago
[#18836]

I was told by Ray Wu the the WS2811 pixels were compatible with the 1804. Unfortunately that doesn't appear to be the case. I have some samples in hand but so far haven't been able to make them work.

As of right now, the E68x controller series will not work with the WS2811s. I'm trying to get some better info from Ray to try to get this sorted out.


25 Replies
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago
jstjohnz wrote:I was told by Ray Wu the the WS2811 pixels were compatible with the 1804. Unfortunately that doesn't appear to be the case. I have some samples in hand but so far haven't been able to make them work.

As of right now, the E68x controller series will not work with the WS2811s. I'm trying to get some better info from Ray to try to get this sorted out.

I was looking at the data sheet for the 2811 and there looks to be a slight difference between the two for the manchester timing so you might want to check it again. It's also possible that they strapped it for slow speed.

I'm assuming that you were running the 2811's on 5V not 12V:biggrin2:

Oh, I found the data sheet on the Ausi forum in the data sheet wiki page.

http://auschristmaslighting.com/wiki_source/images/b/ba/WS2811.pdf

http://auschristmaslighting.com/wiki_source/images/4/49/TM1804.pdf

John


Reply
Jeff Millard
Posts: 1450
(@jeff-millard)
Noble Member
Joined: 19 years ago

http://tinyurl.com/4ukg4


Reply
Posts: 1249
Topic starter
(@jstjohnz)
Noble Member
Joined: 17 years ago

It's been a while since I have looked t thgis but I believe it turned out that what were supposed to be 2811s were in fact TLS3001s. I received a selection of several of the newer pixel types from Ray recently, I just need to sit down and test all of the 'new' types.


Reply
Posts: 1249
Topic starter
(@jstjohnz)
Noble Member
Joined: 17 years ago

I finally got around to testing "real" WS2811s. The issue was timing. When setting up for the original 1804 pixels, I found 3 different data sheets with 3 different timing specs, so what I did was find the range where they worked, and set the final timing in the middle of that range. It turns out that that particular timing is just a hair off for the WS2811s.

So now the WS2811s are working, they will be setup as 1804s, I just need to verify that the 1804s still work properly, and of course I can't find my string of 1804s to test that...


Reply
Page 1 / 6
Share: