I got a little ahead of myself when assembling my first E681 and didn't install the two 32-pin SIP sockets used for the resistor networks. I soldered the resistor networks directly to the PCB. Are the resistor networks known to fail, or are there different values used for certain configurations?
In other words, should I spend the time reworking the board, or not worry about it? I'm inclined to leave it as is with the resistor networks soldered in place, but if there's a compelling reason to put in the sockets, I'll do the work now rather than later.
Well - - for the 1809 strips you actually have to have jumpers (or very low/0 ohm resistor packs) installed instead of the supplied resistors so I guess the answer is - possibly/maybe...
Based on what I've seen mentioned from others - if you're using 2801 and probably 6803 style nodes with the E681, you're probably OK with the resistor networks supplied with the kits.
If, as Brian mentioned, you're going to use the 1809 or 3001/4 nodes, you may have a problem, depending on how long the distance to your first pixel.
The intent of the SIP sockets was to be able to replace the network with the correct value for the nodes you are using.
What about with GECEs? You've both mentioned 1809, 2001/4, 6803, but not what I'm going to be using!
I read the installation manual and configuration manual and the only thing I've seen is a step mentioning installing either 270 ohm or 330 ohm, but not what configuration is for what. Thanks for the replies!
Well, I'm impatient, so I removed the networks (they're only 14¢ a piece) and only accidentally removed 1 pad. I should have the E681 up and running today.
I still would like to know what the proper network is for GECEs. I've looked through all of the PDFs available on sandevices.com, I've looked on the DIYC wiki, as well as done forum searches, and I haven't found anything about those other than they need to be switched for certain configurations and they're required.
