Hello all,
I'm having issues with 12v pixel strings dying mid-way into a strand. So far they have:
1. Flicker all random colors and send no additional data down the line. (1 instance)
2. Look like a 'low voltage' pixel, and send no additional data (3 instances)
3. Look like #2, but send data anyway (only 1 instance, left that on in place for this year)
Power supplies are set at 12.3V, F16V3 is set to 70% for all strands, max cable length is anywhere from 3 to 50 ft (16/3 power cables) with 30 ft or 50 ft CAT5 data cables. All DIYLEDExpress pixels. No other issues so far.
I've got about 2k pixels this year, and this is my first year. Is it common to be dealing with these types of issues? Is the issue burn-in time? So far i just splice them out and replace, but that's really annoying to do on some of my house outlines (3 of the 5 failures), only two out on same strand at different times.
Couple things I learned as a newbie this year. Your 12v PSU should actually be at around 11.85 to 11.90. Possible the higher voltage is causing failure. Make sure ALL your grounds are connected. Not V+, just grounds. Double check connections. Look into some gel filled dolphin connectors for quick fixes until you get them down and make permanent fixes. You really shouldn't need to have lights set at anything above 50 percent. Honestly.
Silly question, but how has your weather been? I haven't had the issue with any pixels purchased within the last 5 years or so, but your first two issues are nearly identical to issues I had with older nodes when they got wet. In almost all cases, they worked without issue after drying out, and have now been removed from the show completely. I say ALMOST all cases, because the ones that didn't work after drying out, resembled your third issue. They'd always pass data downstream, but one or more color would be lost in that individual node. Water intrusion is the first thing I would check.
Probably not the poster's problem, but isn't 30-50 foot data cables on the too long side without null pixels? I'm asking for my own benefit.
I have my longest run to my arches at 75' with cat5, and no issues. The falcon boards really seem to push a good distance.
Update:
The last #2 failure mode I had (roof outline) corrected itself after a few days. Not sure if it was due to a system reset or not. Up until this week, it's been mostly below freezing/snow (Northern Indiana). Had no issues with the rain in the last week. Haven't adjusted my power supplies yet, but plan on doing so as a precaution soon. Did drop the brightness down to 50% with no real visual difference.
I will add that the time i had the second occurrence of a #2 and #1 happened when the circuit breaker was tripped (running the vacuum off of the same circuit doesn't work very well).
