DDP settings when u...
 
Notifications
Clear all

DDP settings when using SD card

32 Posts
4 Users
2 Reactions
3,581 Views
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago

Also I can ping the controller from the output page of FPP.

Fpp2
Fpp1

Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
townshend lights wrote:
Thanks Martin.

Turn off send fpp. You are the remote device, not the producer of the fpp sync messages. You will seriously confuse other devices on the network and drive your network to distraction.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

One more screen shot. I need to see the status page (leave the admin mode turned on).


Reply
Posts: 133
(@mel4853)
Estimable Member
Joined: 19 years ago

townshend lights, did you get this working? I'm trying to get mine to work like this and put it on the back burner for now. I'm running all WIFI with DDP for now but I know this will come to an end when I start adding more controllers.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

With admin mode turned on, the status page will report if there are any errors seen when processing the fseq file. I suspect you may be sending the ESP a v2 uncompressed file. That will be clearly identified in the error messages.


Reply
Page 3 / 7
Share: