DDP settings when u...
 
Notifications
Clear all

DDP settings when using SD card

32 Posts
4 Users
2 Reactions
3,583 Views
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago

Well that didn't go according to plan. I made the changes as per above. I could ping the controllers but FPP could not see the controllers, so no lights.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

You should see the controllers in the multisync screen. Are you saying they do not show up?


Reply
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago

They do show up just no output. The sequences are on the cards and on the Rasp Pi. Active is turned off in the outputs and enable is ticked for wireless (not eth) I'm connecting my rasp pi to my AP by wifi and the controllers connect to the AP IP address.

Should I be doing anything in Xlights and reupload controller config?


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

no. post a picture of the device config screen


Reply
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago

Thanks Martin.

controller 2
controller1

Reply
Page 2 / 7
Share: