DDP settings when u...
 
Notifications
Clear all

DDP settings when using SD card

32 Posts
4 Users
2 Reactions
3,590 Views
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago

We might be OK. I did a reupload of one of the sequences using Xlights, I then unticked active in the outputs of FFP and disabled Input one in ESP4.
When I ran the sequence again either from the status page or test sequence page of FPP the lights worked and I could see the sequence running in the status page of ESP4. Now to go through the rest on the sequence uploads.


Reply
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago

@MartinMueller2003 I want to thank you or helping me through this. The display is up and running. The sequences look way better running from the SD cards.
Two little issues I had today which I sorted but thought I would mention them.
1. when I set the first input to disabled it would change to DDP when I uploaded the seq through Xlights. So I had to change them back.
2. My mega tree sometimes freezes at the end of the play list and I have to reboot the controller. I think I fixed it by turning on "Bland between sequences" in FPP.

Other than that, I'm very happy. Thank you again.


Reply
Page 7 / 7
Share: