DDP settings when u...
 
Notifications
Clear all

DDP settings when using SD card

32 Posts
4 Users
2 Reactions
3,582 Views
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago
[#58417]

I'm using SD cards in my D1 Mini/D1ESP32 boards. In ESPS4 what should my primary input be? I currently have it set to DDP and I'm getting controller disconnections and that controller will pause untill it comes back on line.

It looks like the display is pushing the sequence data out by DDP rather than reading the SDcard as when I go into the Output settings and untick "Active" for that controller, then there is no output to the lights. I would have thought that the lights should keep going if it's readying from the SD card?


31 Replies
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

If you are using the sd then you do not need anything for the primary input.


Reply
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago
MartinMueller2003 wrote:
If you are using the sd then you do not need anything for the primary input.

Sweet, I'll change it tonight. Should I also untick active in the output page of FFP? I've seen that mentioned in a few places while researching the answer.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Correct. No need to send data from fpp.


Reply
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago
MartinMueller2003 wrote:
Correct. No need to send data from fpp.

Thank you.


Reply
Page 1 / 7
Share: