Cutting Pixel Strin...
 
Notifications
Clear all

Cutting Pixel Strings

10 Posts
4 Users
0 Reactions
3,007 Views
Posts: 126
Topic starter
(@lightsbygreg)
Estimable Member
Joined: 19 years ago
[#23501]

Can digital pixel strips such as these sold by Ray Wu be cut short at designated increments? I'm looking to make a star, and I like the linearity of the strips vs standard pixels. Sorry if this one has been covered before - I couldn't find it by searching!


9 Replies
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Yes can be cut at every chip - the 6 gold coloured pads between the pixels are the solder points to connect the wires - you cut between them so 3 stay on each end.

From the description "waterproof in silicon tube" - if its like the ones I've seen, it has pros and cons - it is a silicon tube that slides over the strip to protect it from the elements. It is easy to slide the strip out slightly to get to the solder pads and then slide back in.
The ends, however are open and need to be sealed with a sealant of your choice before taking outside. Not a big problem.


Reply
Posts: 126
Topic starter
(@lightsbygreg)
Estimable Member
Joined: 19 years ago

Not a problem at all. Thank you!


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

I would test this first before hacking up all your strips. My 1809 strips had cut marks (gold pads) every 10cm but could only actually be cut at 50cm lengths. Why on earth they had them this way is beyond me. Newer 1809 strips didn't have this issue...


Reply
RobG
Posts: 1255
 RobG
(@robg)
Noble Member
Joined: 14 years ago

I have those and yes, they can be cut into any length you need, even single pixel. The strip comes in a silicon sleeve


Reply
Page 1 / 2
Share: