Blue Cast throughou...
 
Notifications
Clear all

Blue Cast throughout WS2811 string

6 Posts
3 Users
0 Reactions
1,988 Views
Posts: 3735
Topic starter
(@algerdes)
Famed Member
Joined: 15 years ago
[#33523]

I have the following:

DIYLEDExpress E1.31 Bridge. Using only one channel of the six (at this time).
DIYLEDExpress Pixel Extender on 18/4 wire about 35 feet from the Bridge. All connection points have been tested for making sure they are tight and "solid".
12 Volt DC Power Supply. Checks out at a perfect 12 volts DC. No drop during this light load.
147 WS2811 Pixels. Brand new. Original string was 100 count to which we soldered the additional 47.

I've used this design over and over again for projects. Never had any problem.
This time I have a blue cast on all pixels.
Even after telling them "all off" (at the controller and when using xlights), they remain with a low level blue cast.
When sending commands to it (controller "tests" and xlights patterns) everything works great. Just a blue cast when they are supposed to be off.
I have tried everything I know, and I have checked all parts of the setup. All soldering is good. All cables are good.

Anyone have any ideas as to what may be going on and where I should be looking?

Thanks for your thoughts and ideas.


5 Replies
Posts: 91
(@rednelb)
Estimable Member
Joined: 13 years ago

Never had a reason to try, but have seen some people try removing the first pixel.


Reply
Posts: 3735
Topic starter
(@algerdes)
Famed Member
Joined: 15 years ago

Interesting. I wonder how the first pixel affects the other 146...
I'll try bypassing it and see what happens.
Any other ideas?


Reply
Posts: 255
(@celtman123)
Reputable Member
Joined: 13 years ago

By bypassing the first pixel it is acting as a "null" this allows the data to be buffered for a cleaner transmission. Just a thought

Sent from my iPhone using Tapatalk


Reply
Posts: 3735
Topic starter
(@algerdes)
Famed Member
Joined: 15 years ago

Whatever the reason was, that pixel extender went belly-up tonight.
Changed it with another and all is well, almost...

We are experiencing something rather strange at this same display.
The first pixel of each of the strings connected directly to the pixel extender is dark.
On the first string where this was found, and before we knew about the others, we cut out the first pixel and connected to the second.
After doing so, the now "first pixel" shows the same signs. Dark, but all pixels after it are working just fine.
We then noticed that each of the other 3 extenders had a dark pixel just off the extender (No more than 3 feet between extender and first pixel. Usually only 9 inches.)

After more testing tomorrow, I'll let you know what we find.


Reply
Posts: 91
(@rednelb)
Estimable Member
Joined: 13 years ago

Is it possible that the extender uses up a channel (or three)? Almost acting as a null pixel ?


Reply
Share: