I dug out the pixels for my arches today and I have a problem. A bunch of the red pixels are out, I saw just a couple of greens out, and all the blues seem to be working fine. There are probably 5-10 out on each strip. These are 5m 12V 60led/m 20IC/m pixel strips in the silicone tube from Ray. They have only been out 1 season inside my HDPE arches.
This video is of them running test pattern 14 on two of my E6804 controllers. I have tried switching strips to different inputs/controllers, rebooted controllers, the same pixels on the same strips are always out so I'm pretty sure it is the strips.
Any thoughts on what to do? :ohwell:
Martin
I got to thinking, I didn't check the output voltage from my power supplies. I checked, and both of them were putting out 11.5 volts. I turned one of them up to 12.3 V, and the problem with the pixel strips has about 80% gone away. Most of the dead pixels are towards the end of the strips. The other power supply stays at 11.5V no matter how I adjust it. I think I have another one around somewhere, I will dig it out and see if I can adjust the voltage any higher. So my question now is this: How high can I turn up the output voltage without destroying the E6804 and/or the pixels strips? Can anybody help answer this?
Martin
Martin, sorry I can't offer a real solution but I know on my setup I had some power issues, but they didn't appear the same as yours, most of mine just went to colors being off - So I would suggest turning down the brightness on the test pattern, I could go down to 25% and had no issues - which worked well overall, 100% outside with 2400 LEDs looked like a beacon for planes. I had to lower it to 10-15% to look good and not out of place outside.
SO, maybe just turn the test down to say 25% to see if it goes away?
