Another pixel contr...
 
Notifications
Clear all

Another pixel controller

292 Posts
18 Users
0 Reactions
81.4 K Views
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

oh....and this is that colorful pin map I mentioned earlier


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

oh....and one more thing....the arduino SPI pins are duplicated on the 2x3 header on the arduino shield. A shield might be connected to one or the other, but not necessarily both. If it's built according to the reference design, the ones on the 2/3 header are the ones you want to connect to.

For Reference:
http://arduino.cc/en/uploads/Main/arduino-ethernet-shield-06-schematic.pdf


Reply
Posts: 217
(@bob-moody)
Reputable Member
Joined: 18 years ago

Thats what I thought I found for the CS pin ... pin 10..... Pin 4 is also a CS pin but its for the SD card.

Thank you for the code .. waiting on your approval to access .

And.... once again.. thank you and thank you to everyone here for the encoragement, education and patience.


Reply
Posts: 217
(@bob-moody)
Reputable Member
Joined: 18 years ago

Loaded the E1.31 2.06 with JC Patterns.spin.
compiled clean.
Figured out the mapping from the Parallax to the Arduino shield (wiznet 5100)
Shield shows pwr, Full HD, 100M, and Link Lights.

Searching the code for the default IP


Reply
Posts: 313
Topic starter
(@ee351)
Reputable Member
Joined: 13 years ago
jchuchla wrote:Bob, your curiousity and eagerness is exactly the qualities that makes awesome developers of new products on this forum. I'll go out of my way to share whatever I know with guys like you anyday. But as soon as you ask "do it for me" then you're on your own! LOL.

anyhow. Here's my code:
The "E1.31 2.06 with JC Patterns.spin" is the program that I'm currently running on a sandevices 681. My starting point on this code was the last source Jim (sandevices) openly published a few years ago. The zip file has some extra stuff that's unused too. There's 3 different driver versions. The active one is the 5100 that's not marked old.

You should actually be able to just remap pins up near the top and run this whole program on your dev board.

This picture shows the CS pin for the Ethernet labeled as ETH-CS

When I click on your link, it says I need permission. Can you post your code here?


Reply
Page 26 / 59
Share: