Another pixel contr...
 
Notifications
Clear all

Another pixel controller

292 Posts
18 Users
0 Reactions
81.4 K Views
Posts: 353
(@bigredsoftware)
Reputable Member
Joined: 15 years ago

I can do a compare test with the Arduino wiznet and quick start board. That would be sweet, I got enough to build two of these bad boys :). I've heard from others the ENJ wasn't a good fit for our purposes when discussing options for a multi universe NRF transmitter using the propeller. If you recode this I can try it out, but I only have WS2801 and WS2811 pixels...


Reply
Posts: 217
(@bob-moody)
Reputable Member
Joined: 18 years ago

Jon,
oddly enough the SD_CS pin is the one I found ...

I beginning to think that maybe what I need to do is quit trying to compete in a Masters level classroom when I'm only an incoming freshman.

Maybe what I need to do is start learning from the bottom... Maybe a simple spin that would read and output the data stream to a serial port (or am I being to ambitious ?) that way I am only working with the Ethernet component. Learn the basics of what each piece is doing, get a firm understanding then add a little something else. Learn how to setup and initalize the Ethernet board, what parms and values are needed, how do you read, write. What does the data stream look like? Now that I have a readable data stream what can I interpret from it and how do I make it do something for me...

I have a feeling that my interaction in this project is just confusing the issue more than adding something of value...

Bob


Reply
Posts: 353
(@bigredsoftware)
Reputable Member
Joined: 15 years ago
Bob Moody wrote:
I have a feeling that my interaction in this project is just confusing the issue more than adding something of value...

Bob

I completely disagree with this statement. You may have discovered something that would effect other users trying to learn or use this code. Always ask questions, always interact with these threads and community members, they will knock your socks off!


Reply
Posts: 217
(@bob-moody)
Reputable Member
Joined: 18 years ago

Believe me my friend.. I know ..
Jon and EE351 both have gone above and beyond to teach me without ever using the classic RTFM repy or simply saying "NO.. that wont work" They both guide and instruct so that learning is a discovery process and for that I cant thank them or DIYC enough ...

I'm just thinking I need more background and understanding.

Bob


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

Bob, your curiousity and eagerness is exactly the qualities that makes awesome developers of new products on this forum. I'll go out of my way to share whatever I know with guys like you anyday. But as soon as you ask "do it for me" then you're on your own! LOL.

anyhow. Here's my code:
The "E1.31 2.06 with JC Patterns.spin" is the program that I'm currently running on a sandevices 681. My starting point on this code was the last source Jim (sandevices) openly published a few years ago. The zip file has some extra stuff that's unused too. There's 3 different driver versions. The active one is the 5100 that's not marked old.

You should actually be able to just remap pins up near the top and run this whole program on your dev board.

This picture shows the CS pin for the Ethernet labeled as ETH-CS


Reply
Page 25 / 59
Share: