Reminds me of the Don Knots movie "The Incredible Mr. Limpett".... Careful what you wish.
Actually I believe I met him at the LSH Academy a couple of years ago.
Bob Moody wrote:Do you ever wonder if the guys that created the SanDevice are lurking and laughing so hard they just shot coffee out their nose all over the keyboard... Thinking .. "OH .. so close .... "?? I'm just sayin .. LOLI know this would add a cost factor of about 5 ... but would a WIZ820IO ($21) or a WIZ550IO ($18) make a difference?
I do have an Ethernet Shield for my Arduino .. from a hardware aspect could that used to experiment with (Wiznet 5100) before calling Mouser and getting something else?Not ready to abandon this path by ANY means .. just thinking ahead .. (and a little sideways ..)
Bob
You bring up a good point. Is it worth the effort to try to squeeze some additional performance from the enc28j60 or would that effort be better spent on using a faster ethernet chip like the w5500?
I would have to defer to you on that question...
All that I am aware about it is what i have learned duning my Arduino project and this one about processing offloaded to the Wiznet board.
I'm still pondering all the players....
The Parallax board
The enc28j60
The Wiznet 5xxx
or the GECE's themselves as a viable element
My suspicions in the GECE's lie in that even with the San Device 6804 there are still anomalies that appear regardless of sending data from LOR or xLights (pixels not lighting up, enumeration issues etc... )
With all that said ..
I am still game to work on this and follow either path..
optimizing the existing project with the enc28j60
Stripping the enc28j60 out and trying a Wiznet option of any flavor
Bob
Anyone want to venture a guess on connecting the Arduino Wiznet Shield to the Parallax?
I found the schematics and I think I can ID 3 of the 4 pins .... (Parallax pins are described as the actual 40 pin connector pin location)
Parallax pin 20 --> SCK --> ICSP pin 3
Parallax Pin 21 --> SI --> ICSP pin 4
Parallax Pin 22 --> SO --> ICSP pin 1
Parallax Pin 23 --> CS --> CANT SEEM TO FIND ??
Problem is all the Arduino Ether shields I find refer to a differernt set of pins (actual pins on the Arduino board and not the ICSP pins)
The driver I pulled tells me that it needs
/RESET, SCLK, /SCS, MOSI, and MISO signals.
I also downloaded the W5100_SPI_Driver.spin in hopes of porting over the driver commands (may be a more than I can chew.. but I'm game)
Anyone game in porting this over to Wiznet?
Do I have the right driver? I know Jon said he had something already in production..
Bob
Arduino dual purposes pins. If you google for arduino uno pinout or pin map you'll see some colorful diagrams showing all the different names and functions for each pin.
If I recall though, I think the arduino shield has two CS pins. One for the wiznet and the other for the sd card. They may be labeled to indicate that difference.
There's two versions of the 5100 driver on the obex last time I checked. One uses SPI and the other uses the parallel interface which won't work with the arduino shield. Not all of the necessary pins are there.
I can send you my version when I get home. It's the same as the SPI version on the obex but has a fix for IGMP support to make it fully sACN compliant.
--Jon Chuchla--
Sent from my iPhone using Tapatalk
