REN48LSD Starting a...
 
Notifications
Clear all

REN48LSD Starting address

9 Posts
3 Users
0 Reactions
4,352 Views
michaelc
Posts: 1540
Topic starter
(@michaelc)
Noble Member
Joined: 19 years ago

Budude.

I was thinking (always a bad outcome!), If I split my DMX signal to the LOR boards and the REN boards. My lor will always be channels 1-80. I have my first REN48 set to channel 81. If I daisy chain multiple REN boards AFTER my first ren48, and have the bit set to default "1" for those subsequent boards. Will the 2nd renard board be channel 129 or will it use channels 1-48 (since the signal is split and the 1st ren only used 81-128?


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
michaelc wrote:Budude.

I was thinking (always a bad outcome!), If I split my DMX signal to the LOR boards and the REN boards. My lor will always be channels 1-80. I have my first REN48 set to channel 81. If I daisy chain multiple REN boards AFTER my first ren48, and have the bit set to default "1" for those subsequent boards. Will the 2nd renard board be channel 129 or will it use channels 1-48 (since the signal is split and the 1st ren only used 81-128?

The 2nd board should/can be left as '1' and it will automatically start at '129' as you surmised. Keep in mind that there is no difference between a Renard board with multiple PICs and multiple Renard boards with one or more PICS when daisy-chained. Logically it's just one big chain. So really what you end up with is a Ren96LSD (or whatever combination of Renards). The PICs at the front always consume the data for the first address set so the first Ren48LSD would 'eat' up 81-128 and the data for channels 129-512 would go on the OUT connector.


Reply
michaelc
Posts: 1540
Topic starter
(@michaelc)
Noble Member
Joined: 19 years ago

so channels 1-80 just get ignored. Sounds good to me. I'm working on a permanent outdoor setup and wanted to be sure. I have one config with channels 1 to 128 for Christmas but the 1st 80 are LOR boards. Those will only come out during the holidays. The channels above (ch 81 to tbd) will all be Renard and be permanent installs of various combinations of Rainbow floods and Superstrips.

I"ve already decided that I will be populating superstrips (when I can get them) with the RGB and the UV LED. The only thing I'm hoping (once I get my hands on the pcb's) is that I can change out some components and run the SS at 12V instead of 5v.

Now to figure a good looking permanent soffit install that will survive the weather


Reply
michaelc
Posts: 1540
Topic starter
(@michaelc)
Noble Member
Joined: 19 years ago

sorry - dup


Reply
Page 2 / 2
Share: