Pickit 3 Programing...
 
Notifications
Clear all

Pickit 3 Programing error

13 Posts
6 Users
0 Reactions
8,184 Views
rredecker
Posts: 45
Topic starter
(@rredecker)
Trusted Member
Joined: 17 years ago
[#13584]

Hello Everyone

I am trying to program a new chip with my Pickit 3 from Sure Electronics and every time I go and power on my programer it says this:
Target Device ID (00000000) does not match expected Device
ID (00001180). This is the Kit I have http://www.sureelectronics.net/gallery.php?id=1141&img=6112

I am running MPLab IDE v8.60 I have followed the PDF and still get the same results.


12 Replies
RichF
Posts: 1356
(@richf)
Noble Member
Joined: 19 years ago

Are you in the coorect socket on the Zif socket board? You should be in the middle sized Zif.


Reply
rredecker
Posts: 45
Topic starter
(@rredecker)
Trusted Member
Joined: 17 years ago
RichF wrote:Are you in the coorect socket on the Zif socket board? You should be in the middle sized Zif.

Rich the one I am using is the 18 pin one

Thanks Randy


Reply
David_AVD
Posts: 991
(@david-avd)
Noble Member
Joined: 17 years ago

Have you set the PK3 to supply power to the chip? I think it's off by default.


Reply
rredecker
Posts: 45
Topic starter
(@rredecker)
Trusted Member
Joined: 17 years ago

yes that is turned on. I followed the pickit 3 PDF to a T. This is why i am so confused.


Reply
Page 1 / 3
Share: