Pickit 2 error code
 
Notifications
Clear all

Pickit 2 error code

7 Posts
4 Users
0 Reactions
7,675 Views
Posts: 141
Topic starter
(@rdartist)
Estimable Member
Joined: 17 years ago
[#13405]

Trying to program my 16f688's for ac use of ren 24lv..
I get :
Programming failed at program memory address 0x000001

Any suggestions? :confused:


6 Replies
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago

With the little info provided, I would say it can't find the PIC on the programming board. What is your setup (programming board, genuine Pickit2?) Are you sure you have the chip in the right socket? Is oriented correctly?

Is this in MPLab or other?


Reply
Posts: 141
Topic starter
(@rdartist)
Estimable Member
Joined: 17 years ago

I have been in and out of the Library (I have no internet) so I was too brief.

the firmware was in a hex file so i thought I didn't have mess with the mplab.

when i went to download from the link in the wiki, i was given v6.61
This loaded a bunch of wizards that looked greek to me...mplap pm3, idc2, and others- all of which showed xp as the latest os

The Pickit 2 is off of ebay, it is silkscreened, but not the black one pictured in the software.

The software sees the unit all the way to the 16f688. I know this because last night at 2am I accidently selected the wrong PIC ad it wrote to it
Once I select 16f688, failure at 0x000001

I hope this gives enough info so I don't have to go outside and run over this thing with my truck!

It's 4 deg farenheight in the sun


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago

Did you try other PICS? maybe there is something wrong with that one now.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
rdartist wrote:I have been in and out of the Library (I have no internet) so I was too brief.

the firmware was in a hex file so i thought I didn't have mess with the mplab.

when i went to download from the link in the wiki, i was given v6.61
This loaded a bunch of wizards that looked greek to me...mplap pm3, idc2, and others- all of which showed xp as the latest os

The Pickit 2 is off of ebay, it is silkscreened, but not the black one pictured in the software.

The software sees the unit all the way to the 16f688. I know this because last night at 2am I accidently selected the wrong PIC ad it wrote to it
Once I select 16f688, failure at 0x000001

I hope this gives enough info so I don't have to go outside and run over this thing with my truck!

It's 4 deg farenheight in the sun

First I would suggest you get the MicroChip PICKit2 software - it's the simplest way to program the PICs IMO (assuming you have .hex in hand as you do). Pop in your PIC, do an erase and verify it's empty and then retry flashing the .hex file again.


Reply
Page 1 / 2
Share: