Homemade Pic Progra...
 
Notifications
Clear all

Homemade Pic Programming Board

6 Posts
3 Users
0 Reactions
5,361 Views
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago
[#13288]

I built a board a couple of years ago, based on some instructions I found at the time. If anybody knows of those instructions, can you point me to them?

I've got the PicKit2. I just want to verify that I have the wiring to the correct pins.

Thanks


5 Replies
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago

Nevermind. I found it.


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 19 years ago

Here is the one I made and use.


Reply
Posts: 157
(@ekuth)
Estimable Member
Joined: 17 years ago

WayneJ;

What's the value of the resistor shown between GRD and VDD?


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 19 years ago
Ekuth wrote:WayneJ;

What's the value of the resistor shown between GRD and VDD?

It's not a resistor, it is a decoupling cap. Not needed in this application, but it is the same one used in the Renard boards. Here is one part#... 80-C322C104K5R (though any of the ones listed in the BOMs of Renards will work if you choose to install it). I just through it in there for extra protection.


Reply
Page 1 / 2
Share: