Activity
 
Notifications
Clear all
slug
@slug
Reputable Member
Joined: Dec 23, 2007
Topics: 50 / Replies: 132
Reply
RE: Ray's Current E-mail

Thank you for the quick answer.

3 years ago
Topic
Replies: 2
Views: 2403
Reply
RE: ESPIXEL WS2811 Prop Strobing

I checked and no test from the pixelstick. That was disabled. The final effect is a pulse fade-out. I may remove that and see if it resolves.

6 years ago
Reply
RE: ESPIXEL WS2811 Prop Strobing

I will do that. Would a test on the pixelstick stop it from executing a second time? It does run through the first sequence fine. I have it unplugg...

6 years ago
Reply
RE: ESPIXEL WS2811 Prop Strobing

Possibly. It will do one loop of the sequence. Then when it should go off, it starts strobing, probably once a second and never stops. All the othe...

6 years ago
Topic
Replies: 7
Views: 2021
Topic
Forum
Replies: 1
Views: 1840
Reply
RE: E682 TLS3001 Color Problem

Barnabybear wrote:Hi, it would be good if you could post the detail of the final fix. I'm not sure about you but I've dived it too far too many thread...

6 years ago
Reply
RE: E682 TLS3001 Color Problem

Numbering fixed it. Thank you everyone for your input.

6 years ago
Reply
RE: E682 TLS3001 Color Problem

I am on v4.033. It could be the 512. I didn't change those values. I just accepted the numbering that was assigned. I can work on that today. Th...

6 years ago
Reply
RE: E682 TLS3001 Color Problem

I will check the fw version in the morning. Thank you for giving me something to check. I am using 12 strings. One 50 node string per port.

6 years ago
Topic
Replies: 11
Views: 2801
Reply
RE: New light controller

Let me know what you need. I think I have all the parts for the 595, and a ton of them at that, if you decide you want to fix it.

6 years ago
Forum
Reply
RE: DIGWDF WiFi SSR

Ok, swapped out power buck, and it was at 5V, until I tried testing the channels. The channels didn't work, so I checked the voltage and it was back ...

6 years ago
Forum
Reply
RE: DIGWDF WiFi SSR

I checked the buck output and it's at 3v, so something must have went bad on it. I'm going to try another one when I get off of work.

6 years ago
Forum
Page 1 / 13
Share: